Introducing the Pulp Consumer Client¶

The Pulp consumer client, pulp-consumer, is a command line tool that allows administrators to register a consumer, bind that consumer to Pulp managed repositories, and install content onto the consumer from those bound repositories.

The client requires the Pulp Agent to be installed in order to communicate with the Pulp server. This is a daemon process that listens on an AMQP bus for messages from the server and uses the bus to send messages to the server.

This page gives a brief introduction to the consumer client and the agent.

Local v. Remote Commands¶

The pulp-consumer command line client is used to execute Pulp commands locally on the consumer machine. Pulp commands may be executed remotely, from the server, using the pulp-admin command line client. Details on the latter are covered in the pulp-admin documentation.

All commands are available locally. And some commands, namely register are only available locally.

Local Permissions¶

It is imperative that the pulp-consumer command line client be execute with enough permissions to write system-level configuration and credential files. In general, this will mean with root privileges. This is easiest with the sudo command.

$ sudo pulp-consumer ...

Troubleshooting with verbose flag¶

You can run pulp-consumer commands in verbose mode to get additional information in case of a failure. Look at the example usage of verbose flag in the admin client troubleshooting section.